Locomotive/s will not move in Cab Control Driver Mode

[Phil_C]

Symptoms;

When trying to Drive a locomotive using in Cab control the levers have no effect and the locomotive will not move;

Cause;

There are two possible causes;
1) The lead locomotive has no fuel added and has not been started.
2) The lead locomotive has fuel but has not been started.

Solution;

1) Ensure you add fuel in surveyor to the locomotive as shown in this tutorial.
2) Start the locomotive either using the manual controls or the driver command as shown in this tutorial. NOTE; Fuel must be added in surveyor or the locomotive will shut down again.

Status

This behavior is a design feature that mimics prototypical behavior. It can be turned off in surveyor.